Originally posted by clmbia45
The holes in the bell housing don't allow this without damaging the bell, it seems to me.
With the stock Centax II clutchbell housing (as well as Centax I), the holes are 180 degrees apart and directly opposite each other.
The optional lightened Centax II clutchbell is like the Centax III clutchbell and they have 3 of these holes at 120 degrees apart.
Still if you look at the Centax II clutchbell housing tool, it only makes use of a single hole on the optional lightened Centax II clutchbell. A pin will go through only one hole and it already holds the clutchbell firmly.
I'm still trying to find a 3 mm drill bit hard enough that would drill my Hudy spring steel Centax II clutchbell housing tool (909593) to align with the Centax III clutchbell holes. Once this hole is drilled, they will fit fine in the Centax III clutchbell to hold it.