Originally posted by rcjayy
Guys
I have a question, when your putting together you 2 speed and you place it on the two speed shaft is there supposed to be a lot of play between the second gear and the bearing to the left of it. I put that round spacer inbetween and its still about 1.5mm to 2mm movment between the two, that dosnt seem right, what could be wrong?
End float in the 2 speed shaft is adjusted by the positioning of the 22t pulley at the other end. Also check that the pins on the 24t pulley don't touch the bearing block.
The 2 speed shaft must have end float or else you can damage the shaft bearings, this happened on the 705 if the shaft was not setup correctly.