Brian- during qualifying I was running calibers, switched to revolvers in the main
Garret- Congrats on TQ, if you hadn't of flamed it would have been hard to beat you.
RoyJ-- You are correct the 09 kit comes with the rear alum hubs, however I use the stock plastic ones just for lighter weight.
Here is part of my setup from the weekend:
Diffs 5-5-1
Shocks F 50, R 40 Stock 1.4 pistons
Blue springs up front, stock in rear
no droop on front arms, rear the set screws are about 10 mill. out of the arm
Long wheelbase
3-3 rear pivot
Plastic chassis braces
3 degrees positive toe out in F
-2 Camber all around
13 tooth clutch bell, stock shoes and springs
Largest sway bars all around
Will get tie rod locations and etc. soon.
Last edited by samos234; 10-23-2009 at 10:18 AM.