Originally Posted by
robk
You really need to run f103 rear tires to get the rear width to be close to the front.
Ackerman looks fine, looks like most 1/12 cars out there
O.K. here's what happened when I just test ran her,
But first, my tire combo: In the rear = Tamiya F103 rubbers (B), Up front = Tamiya F103 foams.
Now, I started by triming, once trimed I gunned it straight. I then turned to the right real sharp. It handled the turn, except instead of being straight once letting go of my steering, it turned to the left on it's own. My trim somehow reversed. So I re-trimed so that I was straight again. Gunned it straight again, except I turned real sharp to the left. Again, should be straight after the release, but instead it turned to the left, on it's own.
Any suggestions????
:flam ing: