Thread: XRAY T3
View Single Post
Old 10-20-2009, 07:48 PM
  #298  
niznai
Tech Elite
 
niznai's Avatar
 
Join Date: Feb 2009
Location: All over the place
Posts: 2,965
Default

Originally Posted by kn7671 View Post
Pulley changes will likely require different length belts.
Yes. I have managed to bring the internal ratio down by using center pulleys with 24 teeth and Xray belts fit well. Of course they need to be changed but that's easy. Just had to buy some of the belts they offer and try them on. That's why I suggested Xray could do this, so we don't have to!

The most difficult part of the modification was that I had to machine my own center pulley/spur holder and I think this is beyond most people's possibilities. If Xray had their own pulley that would just "bolt" on, the job would be easy as the belts needed are available already from Xray.
niznai is offline  
Reply With Quote