Originally Posted by
JoelV
0/-2
1/-1
Before we even got our cars we had these in mind. They go based off the same convention Schumacher uses with the 1/2/3 groove camber link mounts. So 0 is 3mm longer center to center than a 1gr. And so on. Main goal was to be able to run shorter camber links.
We have been running 0 front and -2 rear links with Foam sedan with great success. Haven't gotten rubber cars yet, but the plan is to start with 1 front/-1 rear. We haven't had to make any wholesale changes to our original planned setup. Just fine tuning it in. Hopefully the same goes for rubber when the time comes.
You may want some more meat between the 2 holes, the force applied to that is going to be severe.