Hey vthondaboi
Forgot to mention that the New Ofna Tire lathe will cut at a taper, so you can cut camber on the Foam.
Foger Rox is right about that, but it also depends on the Foam hardness and what Camber, Caster, and Toe-in. your using.
Yea, it can be a science in itself...hahaha If your in Florida just go to the Serpent Track. I've watched guys there spend all day cutting and trying tires. Then watch Mike Salvan(spelling???) come out there and SMOKE EVERYONE on old tires!!! hehehe Soooooooooo hahaha
Keep the Rubber(or Foam)on the Road!!!
Bradley J. Gotori
[email protected]