Originally Posted by
kschu
this is how im doing
1. i on my car and gun and steering trim set to 0
2. i make sure d steering ankerman is in middle
3. i set my toe to 0deg using hudy setup. Both is 0 deg.
4. i measure the length left n right steering rod using digital caliper, but the measurement is different?
Do it the way I suggested. You are setting steering off your servo. That's not right. You need to keep your radio and car OFF. Set your steering rods the same length. Set toe with same length. Then adjust your servo horn and servo linkage to match your new toe settings.