I need some advice, I have got a used 8ight to where the back of the chassis is worn down thin. It's not worn down all the way but I had to cut grooves in the back 2 screws to get them out. I would say it's less than half left. So my question is, until I get a new chassis for it will these work for now?
http://www.amainhobbies.com/product_...si-8-8T-20-20T
Also I will ask here to. I can't seem to find a back plate on A-Main that I can use for the losi 427 motor to convert to a bump box. Does anybody know if the make one or where I can locate one at?