R/C Tech Forums - View Single Post - Associated RC12R5
Thread: Associated RC12R5
View Single Post
Old 10-01-2009 | 11:20 AM
  #1631  
Sean Cochran
AE-Reedy
iTrader: (1)
 
Joined: May 2008
Posts: 811
Default
Originally Posted by Chemical X
Are any of you running a JR servo in your 12R5 or 12R5.1? I recall reading that Sean C runs a JR servo. My question is... Did you drill new holes in the chassis to use the servo mounts or just Shoe-Goo the servo to the chassis? If you drilled new holes, did you flip the servo over so it is on the left side of the chassis and then mount the ESC on the right?

Thanks in advance.
Yes I re-drill the chassis for the JR servo. No I do not flip it over, I move it as far forward in the car as possible. It is also possible to shoe goo the servo but that obviously is a little messy to clean up when you have to remove it.
Sean Cochran is offline  
Reply