R/C Tech Forums - View Single Post - Hpi Pro 4
Thread: Hpi Pro 4
View Single Post
Old 09-30-2009, 03:07 PM
  #15616  
RCFREAK
Tech Elite
iTrader: (20)
 
RCFREAK's Avatar
 
Join Date: Sep 2001
Location: MEMBER OF THE "MWC" Mimi Wong Clan
Posts: 2,442
Trader Rating: 20 (100%+)
Default

Originally Posted by Super Steve
o...
I was hoping that it would.
since the width is the same.
I guess where the gear mounts are centered differently?
im almost sure it doesnt fit... i looked at both spools side by side, the cyclone bulkheads are wider than the transmission housing of the pro4, meaning the width will not fit due to the spacing. i was looking to run a spool in my Pro4 recently.... and have both cars.. if they were the same width, the shock towers would also be interchangeable but too narrow on the Pro4.
RCFREAK is offline