Originally posted by Schrijver99
Original the ballcup couldn't pass the servo horn because the horn had to pull the ballcup passed the centre of the metal servoconnetion. Now with horn not at 90 degrees with the servo but with the lever this is smaller.
Let me get this straight... To get the steering the same left and right, you need to shorten the linkage to 40 mm and then the servo horn at 90 degree to the linkage and not 90 degree to the servo casing?
BTW, what linkage and ball cups did you use? It seems it is quite impossible to get to 40 mm even though you trim the ball cups...