R/C Tech Forums - View Single Post - clutch bell question
View Single Post
Old 09-29-2009, 08:56 PM
  #11  
snowboard094
Tech Master
iTrader: (5)
 
snowboard094's Avatar
 
Join Date: Jan 2009
Location: Sac Town CA
Posts: 1,973
Trader Rating: 5 (100%+)
Default

Originally Posted by Integra
Once in a while Integy make's good parts....i would'nt 100% discount them right off the bat....for example...the HPI savage's were always plagued with the rear knuckles that were retained in place with a turnbuckle that would always pop off and force you to replace or pop it back on...more then annoying to say the least....and then came Integy with a somewhat knock off of what HPI did for the Upgrade Suspension system and sure as Shi* ive beat those rear knuckles to death and they have yet to fail...i have heard of a couple failure's..but the guys were also bragging about it being pretty ridiculous air and or a gnarly landing went bad...so if the gear is cheap enough i say its worth a shot.
Well if i can pick up a cheap bell that will fit: like a savage one (if it will) i would rather do that then spend $20+shipping on an integy spur.
snowboard094 is offline