R/C Tech Forums - View Single Post - Hot Bodies Cyclone
View Single Post
Old 09-29-2009, 06:21 AM
  #17498  
rcracer1958
Tech Fanatic
iTrader: (52)
 
Join Date: May 2008
Location: Poughkeepsie,New York
Posts: 809
Trader Rating: 52 (100%+)
Default

hopefully someone can help me
just got an original cyclone(black edition) and i've been trying to get a rubber tire setup on the car. all the sheets i've found are showing 1.5mm under the hinge pin holders,in the front, the arm spacing is 2.3mm rear, .5mm front, and ackerman is 4mm. when i put this setup on the car, the steering tierods jam against the rear hinge pin block(they actually rub slightly with no spacing under the hinge pin block)
how do you get this setup to work or am i misunderstanding it ?
any help would be greatly appreciated
rcracer1958 is offline