R/C Tech Forums - View Single Post - mid range needle
Thread: mid range needle
View Single Post
Old 09-22-2009, 11:04 AM
  #7  
ScottyM
Tech Elite
iTrader: (27)
 
ScottyM's Avatar
 
Join Date: May 2009
Location: Miami OK
Posts: 3,149
Trader Rating: 27 (100%+)
Default
Originally Posted by PTP Racing
Your going to need to tune the engine before you seal it. I would probably put it in dry tune the engine and then just silicone over it when its properly adjusted. Sealer or loctite will not hold if you turn it after the initial installation and drying of the product.
AH LocTite will.. Because it always stays somewhate wet and everytime it the threads are moved it opens new pores and allows it to adhere again..

You are however correct that silicone will not reseal..
ScottyM is offline  
Reply