Julius / Rene,

Looking at the setup book that comes with the 710 kit, the recommended setup on the last page details that the front and rear tires should be 62 mm.

So, if I use a new set of tires (approx 66 mm), then my set up ride height should be at 4 mm but my front downstops should be +2 (instead of 0) and rear downstop should be +9 (instead of +7). Is that correct? Why is there an upstop?

What about changes to the stock front and rear roll center positions when using the larger 66 mm tires? DRS arm position? Thanks.