R/C Tech Forums - View Single Post - Best Dyno
Thread: Best Dyno
View Single Post
Old 12-17-2003, 06:24 PM
  #31  
dtm
Tech Champion
 
dtm's Avatar
 
Join Date: Aug 2001
Location: HKG
Posts: 7,551
Default

I have the CS.....as previously mentioned, the power source can be a pain to getting consistent reading. After charging a pack you normally have to do a few dummy runs to take the peak off the pack so you can get consistent readings. Also, it will struggle to do 9T and below. The manufacturers answer to this is to run 2 packs in parallel.....this works but sends all the readings haywire (ie. you cannot compare your 10T with 1 pack against your 9T with 2 packs)

However, overall it does do the job and it is pretty small. You just have to be careful how you use it to get some comparable numbers.
dtm is offline