Originally Posted by
AndysD8
Well I measured the chassis and it's 2.5mm instead of 3.5mm, but you're right , no squiggly slits in the chassis. It does however have all the screw holes to move the aluminum stands around like listed under the mft page of the setup book. So without the squiggly lines which I'm guessing allow for the mft is it useless to move the aluminum stands around trying to get a softer or stiffer setting? Wouldn't I want a softer setting for carpet with rubber tires?
I would remove the stands completely, get as much flex as you can in the chassis. If by chance you can get a original chassis it would be better, but this is about as good as you can do with the one you have, at least it is a 2.5mm and not 3mm or more.
And I think I gave you a foam tire setup earlier, try this one instead:
http://forum.teamxray.com/xform/inde...D=753&setup=t2
I copied the wrong one earlier, sorry.