Originally Posted by
bigmatt
You didn't put the con rod piston in back wards? If it worked when you took apart should work when you put back together. Is the crank all the way in? Do you have the sleeve set in correctly? I use dish washing soap to install my seals. It dries up and will not crack the seals.
Sorry guys i meant the crankshaft would not turn properly not the con rod
I assemble everything in correct order, its just that it will turn to some degree but will not turn over (I have to force it to make it turn over. It was difficult to take the crank shaft out when I took the engine apart. I told my LHS that it seems that the bearing does not align properly, it looks offset a little bit however I put it back in
But when they replace the crank shaft every thing is ok but still a little bit tight when turning at some angle
Wat do the engine factory use to lub the O rings, I thought rubber grease
, is it same as automotive rubber grease ???