R/C Tech Forums - View Single Post - Team Losi JRXS Type-R
Thread: Team Losi JRXS Type-R
View Single Post
Old 09-09-2009, 03:19 AM
  #10452  
John Tag
Tech Champion
iTrader: (42)
 
John Tag's Avatar
 
Join Date: May 2004
Location: Huntersville, NC
Posts: 8,925
Trader Rating: 42 (100%+)
Default
Originally Posted by Greg Sharpe
I don't even bother sanding the aluminum hex adaptor, I simply sand the injection molding seam on the plastic hub. Takes two seconds with some light sandpaper.

I found this out swapping hubs between my Type-R and mid-motor JRXS, but it isn't a big deal.
I do that also...I take away about .3mm off face of hub where outside bearing is. When completed the outside bearing shoulder is slightly exposed...
John Tag is offline  
Reply