R/C Tech Forums - View Single Post - KEEP IT RUNNING
Thread: KEEP IT RUNNING
View Single Post
Old 09-04-2009 | 06:16 AM
  #6  
.:hyperdrive:.'s Avatar
.:hyperdrive:.
Tech Adept
iTrader: (10)
 
Joined: Oct 2007
Posts: 168
From: Central Coast
Default
Originally Posted by cluffy1
the CVD's in the car are open which allows the pin to fly out if the grub screw gets to loose and i end up losseing the entire assembly and have to rebuild this. i have tryed everything even superglue and red locktight at the same time i am looking for ways to stop this i have no problems with anything else.

thanks
dane
Provided that there is some clearance, a little trick is to use a narrow piece of heatshrink over the pin around the cvd half so you don't lose the pin easily.
.:hyperdrive:. is offline  
Reply