first off this is converted to a on road car now,(thats why i put it in the on road section)NO STOCK PARTS ARE LEFT AT ALL, ALL CHANGED TO UPGRADED ONES, THERE IS NO OTHER JATO WITH THIS MUCH, I CHECKED EBAY, GRAIGS LIST AND ALL THE FORUMS GALLERYS, NO ONE HAS THIS MANY PARTS OR CUSTOM MADE PARTS AS I DO!! YOU ARE LOOKING AT ONE OF ONE MADE JATO! THE MODS ARE AS LISTED HERE:
-FULLY ported and polished 3.3 engine sleeve and carb.(now a 5.0)
-polished and balanced crank and push rod
-o.s. head
-K AND N AIR FILTER
-custom made cnc titanium machined tranny gears(all the internal gears)
-nitruos oxide system with a custom S8 reed( to let more nos in the motor)(rb innovations only makes up to a S5 reed)
-5 piece carbon fiber kit
-custom cnc machined top brace plate
-custom cnc machined bottom chassis
-custom made cnc machined crankcase cover
-aluminum shocks
-alum. shock tower
-alum. bulk head
-alum. bumper brace and bumper
-alum.a-arms(front and rear,shaved down for less wieght)
-alum. wheel hubs and carriers - also shaved down
-titanium custom made front and rear tie rods
-titanium steering rods
-titanium cvds (rear axles)
-steel braided fuel lines
-grafite brake pads (look of carbon fiber)
-high heat cross drilled and slotted alum. brake rotor
-alum. brake arms
-roll cage
- and alot more that i can not think of. IF THEY DID NOT MAKE A MODIFIED PART FOR THIS THAN I EITHER MADE IT MYSELF OR I WENT OUT AND HAD ONE MADE! NO MATTER WHAT THE COST!!
