Originally Posted by
adamge
There are only two possibilities:
1. The internal code compares voltage to a cutoff voltage setpoint that is too low.
2. When it sees the voltage below the cutoff voltage setpoint, it doesn't actually cut off throttle in a way that the driver notices.
I think you are right, the other day i put my Lipo on my charger after my run and I see it read 5.75V. On my other esc I set the cut off at 3.2v per cell. I ve been told the SXX would cut off around 6v region but in reality it goes well below it. Anyhow performance wise the SXX is very good. For precautionary I just don't run my car beyond 5 mins right know, be it continuous or have a stop during the run.