R/C Tech Forums - View Single Post - Tamiya TB-03
Thread: Tamiya TB-03
View Single Post
Old 08-25-2009, 06:42 AM
  #930  
teamstrc
Tech Master
iTrader: (23)
 
Join Date: Sep 2007
Posts: 1,195
Trader Rating: 23 (100%+)
Default

Originally Posted by jdmcoupe86
hin guys,

which length of universals should i use (Balldiff)? the manual say's 51092 46mm universals. but the tb-03d manual say's 54078 44mm universals. is there any difference between the normal tb-03 and the drift spec? and i'm planning to get a spool in the front, which universal's should i get in this case?

which pinion would you suggset for an team orion revolution 12t motor with tamiya 0.4 spur gear?

thanks in advance
44mm is the one you want to get. I bought the 46mm ones when I originally built the car and it puts the dogbone end way too deep in the diff outdrives (especially with a spool up front...it binds a bit) in the rear, if you plan on upgrading to the aluminum diff, which allows you to run the blades, then the 44mm is the one you need (46mm will be too long again)

Steve
teamstrc is offline