View Single Post
Old 08-21-2009, 08:46 PM  
Tech Regular
xyzyx00's Avatar
Join Date: Oct 2008
Location: SoCal
Posts: 251
Trader Rating: 4 (100%+)

sounds to me like the idle speed screw is set too low and you have compensated for this with your radio trim (+) which makes your idle ok, but when you brake it pushes that slider back past your idle spot to where the needle is set (too small an idle opening) and it dies. you need to set your trim back to zero and turn that needle in until it idles. when you brake it shouldnt close that idle gap.
xyzyx00 is offline   Reply With Quote