Originally Posted by
ace921000
I am getting the go-tech 5 port today for my buggy. I was wondering if anyone had any tips on breaking in the engine? Should I go straight to the groud or idle 2 tanks but keep the temps up in the 200s. What is a good break in temp for this engine?
Idle 2 tanks with foil wraped around the head. Keep the heat up to 210 degrees. Let it cool down and run 2 more at wide open throttle, but keep it rich so it does not over rev. Again, keep the temp around 210. After you run the 4 tanks, tune it to race settings. Keep in mind you will still have a lot of pinch so your temps may get a little high. After you run 2 or 3 tanks through at WOT, I would recomend a good cleaning...