Originally Posted by
da_John_wee
no no no ....you dont have to remove too much from a castor block. just about 2mm. just make sure you trimmed the shrink tubing in right length. the shrink tube just have to go over a pins, no longer than that.
bielive me shrink tubing is da BEST.
I never cut anything away from my castor blocks to get my LCD's to fit. After I shrink the heat shrink I then trim it so there is nothing overhanging. It has been so effective that I have removed the grub screw from my RCD's and use heat shrink on them too.
I have a wicked idea I will run by paul for a simple fix to retaining batteries with the flex setup.