Originally Posted by
ChadRacing
How do you install the front stabilizing wing on the rc10B4?
I cant figure it out...
Yeah...cant's say anything else. But it isn't too bad. Okay, you have cut it out, right? The "rounded" end will be facing down. And the whole thing mounts from the rear of the shock tower. Maybe put a little strip of servo tape on the flat part, that will be against the back of the shock tower. The "round" end will be basically touching the nose of the body, and the top part will fit in under/inside the shock, and fit into place. When installed, just picture the air being scooped, and re-routed behind, and up the shock tower, and released out of the top. Hope this helps.