Originally Posted by
John Stranahan
Conrad-My Ballistic 3.5 is 1.847 long to the shoulder. The narrowed end is .990 in diameter. Length of can is 2.080. I am told this is too much motor for a 1/12 scale.
I imagine the whole series is the same size. No connectors please.
Thanks mate, it will be touch and go if it fits without needing to remove any material. I'd need to have a motor to check it properly but i think the motor pod would get off with a light shave at best so i wouldnt need to loose the extra mounting hole. Just need to wait and see if it will be homologated over here for 10.5 before stumping up the pennies.
I notice the lrp/nosram motors (x11/storm) are stepped as well but not as much as the novak from the pictures i've seen, does anyone have dimensions of these.
Originally Posted by
abailey21
I'm going to snap a pic of the new SP motor in the rear pod of a Speed Merchant Rev 5 in the next couple nights and I'll post it on here to show the new motor fitting
I seen a pic of that from the euro's but i'll be damned if i can find it again now i'm looking for it
Apparantly the feedback from the drivers was the motor was smoother than the equivalent solder tab and there is a lower resistance drop using the connectors. Any chance you could get some sizes of the motor when you snap a pic Adam?