Originally Posted by
zonda
Hi, sorry to hijack the thread, but I've just picked up a used Go 5 port
(still needs more runing in) I've read on here that the dynamite pipes work good with these engines.
could you tell me if this one is ok.
http://www.modelsport.co.uk/index.ph...n&ItemID=32904
Also would the tuning bible at the top of this page be a good reference for tuning these mills.
Many thanks
Rob
Hi Rob, Couldn't get any info from that link, but if your going Dynamite pipe, then the 086 is the one you want. If you want to splash out a little more the pipe worth buying is the new GO 2072. It hauls on the 5 port.
The tuning bible is very good, especially the section on idle gap and low speed needles being too rich. The GO's (most of them, and I'm assuming yours is fairly recent) have a long tapered low speed needle which tunes totally different to most other normal length needle carbs out there.
You have PM on tuning details. Also check out the Massive Mods Tech Tips page on the web site at -
http://www.massivemods.com.au/index....d100c746824203
Lots of good info there
