Ok its time to post about the E4FS rubber setup car with the one way that I just received. I traded a friend of mine for it. Car is brand new and never been run (just built). Now I read almost every page on this forum and not sure about all the other cars but mine is bone stock out of the box. I checked out the Wolf site and everything matches up with the E4FS with the One Way setup that is listed for rubber racing and has the 2.0588 reduction.

Ok It took me all but 2 minutes to figure out how to fit the DUO brushless motor in this car. I did put in the Tekin and will lightly sand the back of the chassis at the endbell on a bevel so the motor will fit perfectly and will make it better for the DUO motors as well. Still very minimal sanding needed and will be a 5 minute job to make look factory. The best thing so far is when I put the wheels on this car it is so free compared to my TC5 and some of my other 2 belt touring cars and this is will stock belts and the bears not being cleaned out at all.

After going over this car for just 10 minutes I very confident that it will work great for me. I did notice with the stock springs and oil it is a little bit too soft of a setup but not a big deal. Just super happy with what I see so far.

I looked at the car before I traded for it and didn't notice half the stuff that I did since it is mine. Can't wait to get it on the track in the next week or two.