Cooper, pinching is something that can go south quickly. Alot of your guys use a hose clamp type pincher, or even the clamp style both of which can make your sleeve out of round. Some also pinch to far down and/or are not tapered to do the job correctly. I will say the above mentioned are credible companies though from everything I have read.
I have within the past several months started a company called the "speed shop". Check out the thread in this forum. I have the same tooling system that Adam Drake uses and it does a great job! I have a lot of good refrences and turn around is pretty quick on something like that.
To do the P/S it's $20 and you can just send the entire engine minus the the clutch, flywheel, etc. We will clean up the engine, bearings, etc.
$60 and we can do the pinch plus install front and rear TKO ceramics.
Just check out the thread and let me know if I can help!