Originally Posted by
racer-007
LOL i should of looked in the box.
i found the operating instructions
it says
the high needle should be 3.25 - 3.5 turns out from fully in. (mines flush)
the low needle should be 1 turn in from flush
and they say its a typical starting point so should i try that?
I would leave the hsn flush but I said I always have to turn my lsn in 1 turn to start..I prefer the flush setting guide for needles as turning them right in can break the tip of the needle off in the housing..if you must do it this way turn it in very gently just till it touches bottom...but flush hsn and 1 turn in for lsn is my standard start point..