I'm loving my Synth. Its been in a Rc8, B44, and now in a Xray 809. I wrap it once with the 1/4" Rx foam used in airplanes.

My B44 was the hardest test for this Rx. It was double servo taped to the carbon fibre. Nothing but 2 layers of servo tape between it and getting slammed hard into the ground twice every 28 seconds (1 lap).

After being moved from car to car constantly for about a season, because it was the only reliable RX I had, the first problem was some major glitching because somehow the antennea was pulled off the board. I opened the case and carefully soldered the antenae back onto the board. Works fine to this day.


Is it true this RX can be run with a 2 cell 800mah Lipo without a regulator?

I have 2 7955 servos connected to this Rx and thats a lot of work for my 7amp Novak regulator to keep up with. My 10amp Castle reg set to 7.0 volts kicked the bucket a while ago.