On another note I ran the car again today,

Surface is a large gas asphalt track – Med grip and with some off camber corners and elevation changes

Found the car responded well to the changes below and was very good at the end of the race meeting

Now running the car as per below

Tamiya Shocks – No foam rebound spacer inside
Springs – 17lb Front & Rear
Oil – 50w FRT, 40w REAR
Shock positions
Front – Top middle hole, Lower outer hole
Rear – Top second hole from inside, Lower middle hole

Wheelbase – kit shimming front and rear
Camber links – kit
Ride height – FR=5.5, R=6
Droop – FR 4mm, R 3.5mm – using droop blocks
Body – Protoform Speed 6

I tried oringing the top deck but did not like it as it made the car feel to flexy and at times too lazy and unresponsive. I also tried a 19 & 17 lb spring combo but it was causing understeer and push.