Originally Posted by
Stealth_RT
http://www.amainhobbies.com/product_...er-Micro-Press
This works good too, and is a lot less than the Hudy tool. You need a vise to clamp it in though, to hold it. So it's kinda hard to use at the track. But then, you shouldn't need to replace CV pins at the track anyway.
the vice part is ghetto imo and the fact that ive seen the pin part Snap more then once make's me cringe when i hear people paying 60$ for one...i would much rather have the leverage of a chain breaker over having to "grab" the tool with Another tool to do the job....and the Hammer presses are a Joke...try and center a pin with a "light tap" of the hammer.