R/C Tech Forums - View Single Post - Setup assist
Thread: Setup assist
View Single Post
Old 07-30-2009, 06:22 PM
  #4  
HellTriX
Tech Initiate
iTrader: (1)
 
Join Date: Jun 2009
Posts: 29
Trader Rating: 1 (100%+)
Default

I finally made a setup sheet. The car is running pretty good now. It still gets a bit loose in the rear about halfway through 5-6 minute runs even with new tires.

PDF attached (hopefully).

TriX

Oh, I'm not quite sure what shock oil is in the car now but I just received my shock oil so I will be trying 50/40 F/R this weekend unless someone has better solutions.

tnx

Apparently my PDF is 950kb when forum limit is 450kb.. So I will list some specs:

Format: Front/Rear

Jaco Blues
Springs: Red/Green
Toe-in: 0 degrees/2 degrees
Spring Mts: 3B/1B
Caster: 4degree/0 degree
Hex Spacing: 0.8/0.8
WheelBase: 2.2/2.2
Steering link: 2B/na
Bumpsteer: 1/na
Shock Position: 2B/1B
Camber link position: 1/2
Outer ball & shims: 0/1.8A
FWD Arm mt: B/B
Fwd Mt shim: 1/0.6
RWD arm mt: B/B
RWD mnt shim: 1/2
Droop: 1.5/2
Anti-roll bar: 1.2/1.5
Shock oil: looks like 40w or 50w in both.
shock piston: 2/2
no rebound
Differential type: Diff/Diff
Diff setting: Tight/light-med (just received my spool today).
Geared for 150F temp after 5min run. (102F day)

ok thanks, gotta run to University class now.

Mario
HellTriX is offline