R/C Tech Forums - View Single Post - Hot Bodies Cyclone
View Single Post
Old 07-27-2009, 07:35 AM
  #17028  
tomracing
Tech Adept
 
tomracing's Avatar
 
Join Date: Aug 2007
Location: Netherlands
Posts: 169
Default

actually you are misreading a few items on the setup sheet.
(4) For completeness, the changes I made from the Hara RROC setup are as follows:
-- more rear roll (rear shock sus arm position > Hara=2, Mine=3 )
-- more damping in front shocks (oil adjustment > Hara=30, Mine=40)setup sheets says 40losi front and back
-- less progressive effect on front swaybar (gap adjustment > Hara=2.5, Mine=1.0)
-- more weight over rear (shifting rear arms via hub shims > Hara=1.0+0.7, Mine=0.75+2.0)
-- bit lower rear RC (top shims adjustment > Hara=1.0, Mine=2.0) ** needed this to plant rear end at the track **
-- front arm sweep (pivot block > Hara=1.0, Mine=1.5)
-- rear arm sweep (pivot block > Hara=1.5, Mine=2.5) hara uses 1.5 shims under the pivot block for rollcentre and a 3.0 pivot block on the sheet
-- less rear end flex (middle deck state > Hara=cut, Mine=solid)

Thanks in advance
but actually i like his titc setup better as a starting point
http://www.petitrc.com/reglages/hotb...TC20090222.pdf
except for the ackerman and shock oil

and finally you have to remember the rear block controls the rear toe-angle which i think will be a governing effect over arm sweep.
tomracing is offline