Originally Posted by
Rick Thomson
You could try them, it's a 0.15 mm difference in size. But normally the 3/32" should fit. Are you sure the pulley is the right one, and with the original holes still intact?
When you will use the 2.5mm balls. Use the ceramic ones,(#1016) it's a big improvement to the cars performance over the normal steel balls. And the wear of ceramic balls is significantly smaller.
Rick
Thanks.
I ordered the only 36T pulley listed; I'll run with the 3/32 balls for now and order the 2.5mm ceramic and install them when they come in.
Thanks for your thoughts.