R/C Tech Forums - View Single Post - new stock motor binary
View Single Post
Old 11-29-2003, 04:08 PM
  #21  
DynoMoHum
Tech Adept
 
Join Date: Nov 2003
Posts: 140
Default

I haven't gotten my hands on one of these new outlaw 'stock' motors yet. I have seen one picture, and it confused me a bit. I thought these motors were going to have four magnets, where two of the magnets were smaller then the other, and this was suposed to effectively increase the timing of the motor. The photo I saw looked like the magnets were split right down the middle just like the Binary Mod cans have...

My testing with quad magnet motors so far, doesn't show much of any differance when compared to the same arm/endbell in a simmilar can with only two magnets. My testing to date has been limited to 19 turn motors.

To me, the only thing interesting about the new Trinity outlaw stock thingy, was that it was suposedly going ot have a variation in the location of the split in the magnets, and now I'm not even sure that is true.

I guess I'll wind up buying one, just to play with...

Not sure we need futher advancements in brushed stock motors... I think ROAR should leave the stock rules as they are...
DynoMoHum is offline