View Single Post
Old 07-21-2009, 08:48 PM
  #800  
JimmyMac
Tech Elite
iTrader: (2)
 
JimmyMac's Avatar
 
Join Date: Oct 2001
Location: NC
Posts: 4,446
Trader Rating: 2 (100%+)
Default

This is what I'm talking about, BD5 spool with modified 415 aluminum sleeves. I do not run them on my car yet. But this is an example. You have to shave them down. I did this before when I ran a 415 spool on the 416 before the 416 spools came out last year. You need them short to fit the BD5 spool cups, and you need the ring to hold them on. The Yokomo SD/BD sleeve is thin and sloted, plus you have to glue it in place. I do not run this setup right now. I do not think I need it yet. I have been fine so far and only broke one cup because of my mistake. But if you run this setup, you will need to change your dogbone/axle to Tamiya 46mm or shave the Yokomo axle pins down because they extend past the cups. (See bottom pic, left axle is Yokomo and right blue axle is Tamiya). Hope this helps. I prefer this setup to steel spools! Steel spools chatter more, weight more, and loose steering.



JimmyMac is offline  
Reply With Quote