Originally Posted by
fitzboy3
does anyone know how to rotate a carb. 180 degrees on a .28 6 port with an 8mm? carb.?
1. Completely remove the pinch bolt IE at the bottom of the carb in the block there is a small screw totaly remove it and the 2 retainers
2. pull the carb straight up (this may be a little hard)DO NOT WIGGLE SIDE TO SIDE as you could damage your carb.
3. Then all you have to do is reinstall the carb in the required direction and replace the pinch bolt make sure you don't over tighten it
hope this helps
Adrian
