Originally Posted by
wayne breault
I'm trying to mount my servo, it's a Futaba S9550, I'm using the forward servo mount position. I put a 2mm shim. The servo tie rod looks stiarght. My problem is the bell crank is hitting the top servo tab and the ball cup is hitting the edge of the servo. Should I cut off the servo tab and drimel the servo case a little?
Now the next problem is I mounted the sway bars a, 1.4mm in the rear and a 1.6mm in the front when I put the collers on and I push up on the rear or front arms a little bit the collers are rubbing the dog bone. Should I put the coller on the end of the sway bar and unscrew the sway bar adjuster higher?
Would appraciate any help.
Wayne
Ack Wayno
I thought you were going to get the 009. Heard good things about this car. I can't wait to see it this Sunday. Go hellhounds?
Now that you actually own one, I wonder if Lee is getting one too
.
Are you going to keep your old Xray?
~Mark