Originally Posted by
wayne breault
I'm trying to mount my servo, it's a Futaba S9550, I'm using the forward servo mount position. I put a 2mm shim. The servo tie rod looks stiarght. My problem is the bell crank is hitting the top servo tab and the ball cup is hitting the edge of the servo. Should I cut off the servo tab and drimel the servo case a little?
Some of the guys at my track have been shimming out 6mm and you won't have to dremel....or you can mount in the rear position. I was looking for a servo mount from someone that I can use so I won't have to shim so much. But with my small electronics I may just go back to mounting in the rear position.