R/C Tech Forums - View Single Post - eZRUN brushless system
View Single Post
Old 07-19-2009, 11:10 AM
  #561  
beemerfan
Tech Master
iTrader: (39)
 
beemerfan's Avatar
 
Join Date: Oct 2006
Posts: 1,709
Trader Rating: 39 (100%+)
Default

Originally Posted by gixer
Fantastic.

Your truck i'll be a bit heavier than me touring car i think?

So the 60a 8.5t should be a good combo on my pro3.
What's your LiPo's 2s?




Cheers
Mark
The truck is heavier than the typical touring car, but not by much. I'm running a 2S lipo. I like the speed control and would recommend it. I don't think you can do much better for the money, although I have read about some people having problems and I'm not sure about getting it serviced. I'm treating it as "disposable." I bought mine directly from a Hong Kong retailer and paid about 105 USD shipped. It was at my house in about 1 week.

The speed control is small and light. The only issue I had was the motor wires were too short for my setup. I had to lengthen them by about 2.5 inches each, but this did not affect the performance of the speed control.
beemerfan is offline