R/C Tech Forums - View Single Post - Team Orion Vortex Brushless motor
Thread: Team Orion Vortex Brushless motor
View Single Post
Old 07-17-2009, 08:29 PM
  #708  
mr fit
Tech Adept
 
mr fit's Avatar
 
Join Date: Oct 2008
Location: new jersey usa
Posts: 163
Default
Originally Posted by HypeRevAE86
I just recently picked up a Vortex Race 6.5T (part no. 28131). Now I have some questions I'm hoping to get answered from all of you. It's going into my Yokomo LCG which is set up for drifting.

How do I set the timing on the motor to zero? (I noticed that the timing mark on the motor is not in the center?)

I'm running a Venom Racing 120A ESC which also has timing advance, what's a good degree of timing to run?

Spur is 96, pinion is 30 which gives me a 7.53 FDR. Temps after running a full pack to LiPo cutoff was about 113F degrees.

I'm looking for a little more speed and torque...any suggestions?
there are 3 screws just above the wire sensor. slightly loosen them( do not remove the screws) advance the timing by going left. retard the timing by going right. the long line line in the middle is zero (neutral) adjust to what ever suits you.
mr fit is offline  
Reply