R/C Tech Forums - View Single Post - CRC 1/10 Pan Car
View Single Post
Old 07-12-2009, 03:11 PM
  #966  
NiMo
Tech Master
 
NiMo's Avatar
 
Join Date: May 2004
Location: Luton, England
Posts: 1,704
Default

Originally Posted by espresso1967
Ok re-buidling now but I am not getting any rebound on the shock. I have installed the o-ring properly, shaft is in nice a snug. I know it has been a while since I first built the shock but just want to make sure that it should have rebound?
I was always lead to believe that a shock should not have any rebound.
It is a damper, not a spring, and its job is to slow down the movement of the moving part, in this case the whole rear motor pod.
but i will stand to be corrected if wrong.
NiMo is offline