Here is a detailed explanation
Hi!!! TRF!!!
Here is what I did, all the parts came from the box of the TBevo.
For the steering linkage that connects to the knuckle arm you need part number MB11, those are the ball connectors with long screws!!! Use them and under the linkage place a nut (not in the box) or the spacer part number E13 on each side then screw the "brass" colored ball connector with part number MC10 underneath, this will clear the gear box!!!
For the linkage that connects to the servo, again use the long ball connector with part number MB11 and add 2 (two) spacers with part number E13 so the link will clear the drive shaft!!!
here is another plus!!!!
Buy a TAO4 Racing Hub Carier (front)
and use the ball connector King Pin to replace the part number MC4
then screw an MB12 or MC10 on the hole where the steering linkage post should be connected with the upper deck!!! Then use the ball up adjuster so that the C hub will have extra support uring aggresive driving!!! The TB evo will have an extra support like the one that the TA04 have (from the upper deck to the C hub!!
Got it???