R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 06-24-2009 | 07:05 PM
  #7447  
bigmatt's Avatar
bigmatt
Tech Master
iTrader: (16)
 
Joined: Mar 2008
Posts: 1,485
Default

Originally Posted by tonydig11
Thanks for the fast reply. I got the c clips but the wrist pin is backordered. Ill back order one then. I only race once a month so i should have one by 2 gallons. And your right about the heat gun . This moter does not like to start when cold.
go to massive mods web site and order one. or fx racing hobbies in canada my have one, also racer22 is a dealer he may have one. I usually just go to massive mods. back ordering some times means they will have a new engine out before you get the parts. They go fast. If you can afford it order 2 of each if you plan on running go-tec's for any amount of time. as far as cold, if I cannot get a heat gun going at the track I will leave the glow igniter on for a minute, then easy rev's for about another 2 minutes. then it's easy driving till it's warmed up. You can always tell when it's warmed up, it all of a sudden comes to life.
bigmatt is offline