hi guys,

just checking if any 1 had encounter this problems before.

i was using a spektrum pro Rx sr3001(on Futaba 3pks in PPM mode) with futaba 3003 servo on my mo3

its use to be ok no problem, but lately, i notice the the servo was unable to get back to its center position, it will take some time to get back like 2 - 3 seconds. which means 1 lap you can get a straight line , 2nd lap you wont get straight line...or if you hit something, it wont be straight, until if you off and on the esc...

i have cross check with other 3 servo (3003) same problem, but if use KO propo servo, the servo will work fine....

i even tested with other spektrum Rx, same problem with futaba servo but no problem with KO servos...

was wondering if the speed controller will have effect on the servos??